Cutlass V6-191 3.1L VIN M SFI (1998)
Pressing Pinion
Bearing Annulus Installation
8. Use an arbor press. Press on threaded end of pinion until it is possible to remove stub shaft, spool shaft seal (20), and stub shaft bearing/annulus
assembly (21).
INSTALL OR CONNECT
NOTICE: If the stub shaft is not held, damage to the pinion teeth will occur.
1. Hex lock nut (32) onto pinion, while holding the valve stub shaft.
^
Tighten hex lock nut (32) to 30 Nm (22 ft. lbs.).
2. Dust cover (33) to gear assembly (30).
3. Stub shaft bearing annulus assembly (21) onto valve stub shaft.
Seal Installation
