Cutlass Ciera V6-173 2.8L (1988)
If date code is not 04/28/87, hose replacement is NOT required. Reinstall convoluted sleeve and proceed directly to Step 10.
Hose Replacement:
4.
Disconnect negative battery cable and remove fuel tank filler cap.
5.
Relieve pressure in fuel system following instructions below:
CAUTION:
To reduce the risk of fire and personal injury, it is necessary to relieve the fuel system pressure before servicing fuel system
components. Unless this procedure is followed before servicing fuel lines or connection, fuel spray could occur.
A.
Connect fuel gage J 34430-1 or equivalent to fuel pressure connection. Wrap a shop cloth around fitting while connecting gage to collect fuel.
Then place cloth in an approved container.
B.
Install bleed hose into the approved container and open valve to bleed system pressure.
6.
Disconnect fuel feed hose at engine and chassis fuel feed pipes utilizing a backup wrench on fittings.
7.
Replace O-ring seals on the engine and the chassis fuel feed pipes making sure Orings are in proper position. Connect new fuel feed hose, P/N
10052161, to engine and chassis fuel feed pipes insuring hose is not kinked or twisted. Torque hose fittings to 27 N-m (20 ft.lbs.) utilizing a
backup wrench on fittings.
8.
Reinstall fuel tank filler cap and reconnect the negative battery cable.
9.
Start engine and check for possible fuel leaks and correct as required.
10.
Install a Campaign Identification Label.
Campaign Label, Parts, Warranty Claim, Owner & Dealer Letters
CAMPAIGN IDENTIFICATION
Each label provides space to print the campaign number, and the five (5) digit dealer code of the dealer performing the campaign. Insert this information
with a typewriter or ballpoint pen. When installing label, clean and dry the surface of the radiator support tie bar and apply the campaign label where it is
readily visible.
PARTS INFORMATION
To ensure parts are obtained as soon as possible, order them from GM Service Parts Operations (GMSPO) on a C.I.O. order, with NO special instruction
code, but order on an Advise Code (2). Use the following part numbers:
Description
Part Number
Quantity Per Vehicle
Hose, Fuel Feed Front
10052161
1, as required
Seal, Fuel Feed Pipe
22514722
2, as required
(O-ring)
NOTICE:
It is estimated that only 12% of the vehicles involved will require fuel feed hose assembly replacement. Order parts accordingly, based on
VIN lists sent to dealers with involved vehicles.
WARRANTY CLAIM INFORMATION
Submit a Product Campaign Claim with the information indicated below. Use only one labor operation per vehicle.
PC PART-NO.
TOT-PTS
TC
LAB-OP
LHRS
ST
SUBLET
Inspect Fuel Feed Hose Assembly Only
96
V4920
0.2*
---
---
Inspect and Replace Fuel Feed Hose Assembly
96
V4921
0.4*
---
---
*
.1 hour for clerical administration may be added to the above operation.
