Cutlass Supreme V6-191 3.1L VIN M SFI (1997)
Rear Knuckle Alignment Link: Service and Repair
Spindle Rod Replacement (Front)
Remove or Disconnect
1. Raise vehicle and suitably support.
2. Tire and wheel.
3. Brake lines from rear suspension support. Refer to Brakes and Traction Control.
4. Rod-to-knuckle bolt/screw and washer.
5. Lower and support fuel tank just enough for access to bolt/screw at rod to frame. Refer to Powertrain Management.
6. Bolt/screw and nut at rear suspension support.
7. Front - rear wheel spindle rod.
Install or Connect
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require