Intrigue V6-3.8L VIN K (1998)
IMPORTANT: Install NEW copper brake hose gaskets (3).
8. Assemble the brake hose bolt (1 ) and the NEW copper brake hose gaskets (3) to the brake hose (2).
9. Install the brake hose bolt to the brake caliper. Refer to Brake Hose Replacement - Rear in Hydraulic Brakes.
10. Remove the nuts securing the rotor to the hub.
11. Install the tire and wheel. Refer to Wheel Installation in Tires and Wheels.
12. Lower the vehicle.
13. Fill the master cylinder to the proper level with clean brake fluid. Refer to Master Cylinder Reservoir Filling in Brake Bleeding.
14. Bleed the brake caliper at the brake caliper bleeder screw. Refer to "Hydraulic Brake System Bleeding" in Brake Bleeding.
CAUTION: Do not move the vehicle until a firm brake pedal is obtained. Air in the brake system can cause the loss of brakes with
possible personal injury.
15. Pump the brake pedal (3/4 of a full stroke) as many times as necessary to obtain a firm brake pedal.
16. Apply approximately 778 N-m (175 ft. lbs.) of force to the brake pedal for ten seconds.
17. Inspect the brake caliper and hydraulic brake system for brake fluid leaks.
