Intrigue V6-3.8L VIN K (1998)
2. Install the ignition coil attaching screws to (1) to the ignition control module.
-
Tighten the screws to 5 N.m (40 lb in).
3. Install the ICM with ignition coils to the mounting bracket.
4. Install the washers and nuts securing the ignition control module to the mounting bracket.
-
Tighten the nuts to 8 N.m (70 lb in).
5. Connect the spark plug wires to the ignition coils (in order they were removed).
6. Connect the 14-way wiring harness connector to the ignition control module.
7. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect in engine electrical.
