Silhouette V6-191 3.1L VIN D TBI (1995)
6. Attach a suitable hose to wheel caliper bleeder valve, and immerse the opposite end of hose into a clean, suitable, container partially filled with
clean brake fluid, Fig. 7.
7. Slowly apply brake pedal one time and hold, loosen the bleeder valve to purge air from caliper, then tighten bleeder valve and release pedal.
8. Wait 5 seconds, then repeat sequence, including 5 second wait, until all air is purged from caliper.
9. To assist in freeing trapped air, tap lightly on caliper or braking plate to dislodge any trapped air bubbles.
10. Repeat bleeding sequence at each wheel until system is bled.
11. Lower vehicle
12. Check brake pedal for "sponginess" and brake warning lamp for an indication of unbalanced pressure. Repeat bleeding procedure to correct either
of these conditions.
Pressure Bleeding
PRESSURE BLEEDING
Fig. 8 Plastic Reservoir Bleeder Adapter Installation
