Silhouette FWD V6-3.4L VIN E (2004)
Stabilizer Link: Service and Repair
Rear Suspension
Stabilizer Shaft Link Replacement
Removal Procedure
1. Raise and support the vehicle.
2. Use a wrench in order to hold the stabilizer shaft link. Remove the stabilizer shaft link nuts.
3. Remove the stabilizer shaft link.
Installation Procedure
1. Install the stabilizer shaft link.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install the stabilizer shaft link nuts.
^
Tighten the stabilizer shaft link nuts to 31 Nm (23 lb ft).
3. Lower the vehicle.