Grand Voyager V6-3.0L VIN 3 (1998)
10. Using a suitable tool such as a 14 mm box wrench or an aircraft type hose clamp, compress the flared legs on park brake cable retainer. Then pull
the park brake cable out of brake support plate.
11. Lower vehicle enough to access the brake pedal.
12. Using a brake pedal depressor, move brake pedal to a position past its first 1 inch of travel. This will prevent brake fluid from draining out of
master cylinder when brake tube is remove from wheel cylinder.
13. Raise vehicle.
14. Disconnect brake tube from wheel cylinder.
15. Remove the 2 bolts attaching the wheel cylinder to the brake support plate.
16. Remove the wheel cylinder from the brake support plate.
17. Remove the rear brake support plate from the rear axle.
INSTALL
1. Install the 4 hub/bearing to axle mounting bolts into the mounting holes in the flange of the rear axle.
