Grand Voyager V6-3.0L VIN 3 (1998)
Intake Plenum Tightening Sequence
9. Place intake manifold gaskets with beaded sealant side up on lower manifold. Put air intake in place. Install attaching fasteners and tighten in
several steps in sequence shown to 13 Nm (115 inch lbs.).
10. Connect fuel line to fuel rail. Torque hose clamps to 1 Nm (10 inch lbs.).
11. Connect vacuum harness to air intake plenum.
12. Connect and coolant temperature sensor electrical connector to sensor.
13. Connect PCV and brake booster supply hose to intake plenum.
14. Connect Automatic Idle Speed (AIS) motor and Throttle Position Sensor (TPS) electrical connectors.
15. Connect vacuum vapor harness to throttle body.
16. Install throttle cable and transaxle kickdown linkage.
17. Install air inlet resonator hose assembly to throttle body.
18. Install radiator to thermostat housing hose and heater hose to heater pipe nipple.
19. Fill cooling system. Refer to Filling the Cooling System for procedure.
20. Connect negative battery cable.
21. With the DRB Scan Tool use ASD Fuel System Test to pressurize system to check for leaks.
CAUTION: When using the ASD Fuel System Test, The Auto Shutdown (ASD) Relay will remain energized for 7 minutes or until the ignition
switch is turned to the OFF position, or Stop All Test is selected.
