Grand Voyager V6-3.0L VIN 3 (1998)
Installing Tie Rod End Nut
Torquing Tie Rod End Nut
9. Install tie rod end into the steering knuckle. Start tie rod end to steering knuckle nut onto stud of tie rod end. While holding stud of tie rod end
stationary, tighten tie rod end to steering knuckle nut. Using a crowfoot and 11/32 socket, tighten the nut to 61 Nm (45 ft. lbs.).
10. Install braking disc back on hub and bearing assembly.
Disk Brake Caliper Assembly Installation
11. Install disc brake caliper assembly on steering knuckle. Caliper is installed by first sliding top of caliper under top abutment on steering knuckle.
Then installing bottom of caliper against bottom abutment of steering knuckle.
