Neon L4-2.0L DOHC (1996)
7. Remove the four trim screws which attach the module to the top instrument panel.
8. Remove two module attaching nuts from the support structure.
9. Lift module up until the electrical connector is visible and disconnect the connector from module.
10. For installation, reverse above procedures.
-
Tighten trim screws to 2 Nm (20 in lb) torque.
-
Tighten the module nuts to 22 to 34 Nm (200 to 300 in lb) torque.
Undeployed Module
Fig. 7 Remove Or Install Battery Cable
NOTE: Use this procedure when removing a module for any reason other than DEPLOYMENT.
1. Disconnect and isolate the battery negative cable.
Fig. 8 Instrument Panel
2. Remove instrument panel top cover.
3. Remove instrument panel right trim bezel.
4. Open glove box and push the sides inward allowing the door bumper to pass and box to open.
