Neon L4-2.0L SOHC (1995)
Wiper Motor: Testing and Inspection
Standard Wipers
Important Information - Read First
Whenever a wiper motor malfunction occurs, first ensure wiper motor wire harness is properly connected before starting with normal diagnosis and
repair procedures.
Motor Will Not Operate In Some or All Switch Positions
1. Check fuse No. 15 in fuse block:
a. If fuse is OK proceed to next step.
b. If fuse is bad, replace, then check wiper functions in all switch positions. If fuse blows again, proceed to voltmeter test step below.
c. If replaced fuse does not blow and motor does not run, proceed to next step.
Fig.7 Wiper Motor Connector
2. Disconnect motor connector, and perform the following tests:
a. Connect jumper wire from battery negative terminal to motor ground strap.
b. Connect jumper wire from battery positive terminal to pin two of connector, then move jumper wire from battery positive terminal to pin one
of connector.
