plymouth Workshop Repair Guides

Plymouth Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 1
background image

Wiper Switch: Customer Interest
Wipers - Operate By Themselves Intermittently

NO: 08-24-94

GROUP: Electrical

DATE: May 13, 1994

SUBJECT:
Intermittent Wiper Operation

MODELS:

1995 (PL) Neon

NOTE:

THIS BULLETIN APPLIES TO VEHICLES BUILT PRIOR TO APRIL 15, 1994, (MDH 04-15-XX), EQUIPPED WITH INTERMITTENT
WIPERS.

SYMPTOM/CONDITION:

Wipers may cycle once or twice and return to the park position, without operating the wiper switch. This can be caused by external radio frequency
interference (R.F.I.), i.e.; CB radio or commercial transmitting antennas. The wiper switch will function normally otherwise, in all operating modes.

PARTS REQUIRED:

1

4661943

Switch, Intermittent Wiper

REPAIR PROCEDURE:

This bulletin involves replacing the wiper switch with a revised part.

1.

Remove three screws holding the steering column shroud, and remove upper half of the shroud.

2.

Remove the mounting screw on the switch, and remove the switch.

3.

Disconnect the wiring harness connector from the switch.

4.

Install the new wiper switch P/N 4661943 by reconnecting the wiring harness connector, installing the mounting screw, and reinstalling the upper
half of the steering column shroud.

POLICY:
Reimbursable within the provisions of the warranty.

TIME ALLOWANCE:
Labor Operation No:

08-80-90-91

0.3 Hrs.

FAILURE CODE: P8 - New Part

Wiper and Washer Systems > Sensors and Switches - Wiper and Washer Systems > Wiper Switch > Component Information > Technical Service Bulletins > Customer Interest: > 082494 > May > 94 > Wipers - Operate By Themselves Intermittently

< PREV PAGE NEXT PAGE >