Neon L4-2.0L SOHC (1995)
Wiper Motor: Testing and Inspection
Intermittent Wiper System
Important Information - Read First
The intermittent wipe function is controlled by the body controller, located in the passenger compartment behind the right side kick panel.
To diagnose system malfunctions that do not involve the
delay function, refer to "Standard Front Wipers" in this section.
Motor Will Not Operate In Some or All Switch Positions
1. Check fuse fifteen in fuse block:
a. If fuse is OK proceed to next step.
b. If fuse is bad, replace, then check wiper functions in all switch positions. If fuse blows again proceed to voltmeter test step below.
c. If replaced fuse does not blow and motor does not run, proceed to next step.
Fig.7 Wiper Motor Connector
2. Disconnect motor connector, perform the following tests:
a. Connect jumper wire from battery negative terminal to motor ground strap.
b. Connect jumper wire from battery positive terminal to pin two of connector, then move jumper wire from battery positive terminal to pin one
of connector.
