Prowler V6-3.5L VIN G (1999)
5.
Using one hand, firmly press the mirror glass/holder assembly into place while at the same time supporting the housing assembly from the
backside with the other hand.
NOTE:
PRESSURE MUST BE APPLIED EQUALLY OVER THE CENTER PORTION OF THE MIRROR TO ENGAGE THE MIRROR
GLASS/HOLDER TO THE HOUSING ASSEMBLY. ONE OR MORE CLICKS MAY BE HEARD WHEN ENGAGEMENT TAKES PLACE. IT
IS IMPORTANT TO MAKE SURE THAT THE GLASS/HOLDER IS FULLY ENGAGED. PERFORM A FINAL RETENTION CHECK BY
PUSHING ON THE MIRROR WITH YOUR HAND ONE ADDITIONAL TIME PRIOR TO RETURNING THE VEHICLE TO THE
CUSTOMER.
6.
Verify proper mirror adjustment functions and retention of the mirror glass/holder assembly by gently pulling outward on the mirror glass/holder.
7.
Repeat Steps 4 through 6 if the mirror glass/holder detaches from the mirror motor housing.
PROCEDURE FOR DR
1.
Installation instructions are packaged with the replacement glass.
PROCEDURE FOR PL
1.
Push the glass holder fully inboard. Then place fingers under the outboard portion of the glass/holder and pull outboard and rearward until this
portion of the glass/holder is disengaged, then push inboard until fully disengaged. Remove the glass/holder from the mirror assembly.
NOTE:
REPLACE THE MIRROR ASSEMBLY IF ANY DAMAGE IS IDENTIFIED ON THE MIRROR MOTOR HOUSING.
2.
If equipped, disconnect the heated mirror wires from the terminals on the mirror glass/holder.
CAUTION:
IT IS IMPORTANT TO MAKE SURE THE MOTOR IS SQUARE TO THE GLASS HOLDER PRIOR TO GLASS/HOLDER ATTACHMENT,
OTHERWISE THE GLASS/HOLDER COULD BE INSTALLED INCORRECTLY CAUSING POOR RETENTION.
3.
Connect the heated mirror wires to the terminals on the back of the mirror glass, if equipped. Then, position the new mirror glass/holder to the
mirror housing assembly.
NOTE:
POSITION THE MIRROR GLASS/HOLDER SO THAT THE MOISTURE DRAIN HOLE ON THE MIRROR GLASS/HOLDER ASSEMBLY, IF
SO EQUIPPED, IS FACING DOWNWARD.
4.
Align the mirror glass/holder to the mirror motor housing.
NOTE:
ENSURE THAT THE PROTECTIVE RUBBER COVER OF THE MIRROR MOTOR HOUSING, IF SO EQUIPPED, IS POSITIONED
CORRECTLY AROUND THE BOTTOM OF THE FINGERS AREA.
5.
Install the replacement glass/holder in the reverse order followed in step 1.
NOTE:
PRESSURE MUST BE APPLIED EQUALLY OVER THE CENTER PORTION OF THE MIRROR TO ENGAGE THE MIRROR
GLASS/HOLDER TO THE HOUSING ASSEMBLY. ONE OR MORE CLICKS MAY BE HEARD WHEN ENGAGEMENT TAKES PLACE. IT
IS IMPORTANT TO MAKE SURE THAT THE GLASS/HOLDER IS FULLY ENGAGED. PERFORM A FINAL RETENTION CHECK BY
PUSHING ON THE MIRROR WITH YOUR HAND ONE ADDITIONAL TIME PRIOR TO RETURNING THE VEHICLE TO THE
CUSTOMER.
6.
Verify proper mirror adjustment functions and retention of the mirror glass/holder assembly by gently pulling outward on the mirror glass/holder.
7.
Repeat Steps 4 through 6 if the mirror glass/holder detaches from the mirror motor housing.
POLICY:
Reimbursable within the provisions of the warranty.
