Prowler V6-3.5L VIN G (1999)
Fig 8 Installed Caliper Bushing Sleeve
7. Holding sleeve in place, work other end of bushing over end of sleeve and into the seal grove on sleeve. Be sure other end of bushing did not come
out of seal grove in sleeve.
8. When the sleeve is seated properly into the bushing, the sealed for life sleeve/bushing can be held between your fingers and easily slid back and
forth without the bushing unseating from the sleeve groove.
Rear
Refer to Front brake caliper, Guide Pin Bushing Service for repair procedures.
Front
Remove
1. Raise vehicle on jackstands or centered on a frame contact type hoist.
Wheel Center Cap Removal
2. Remove the center cap from the wheel. Center cap is removed by inserting a trim stick into the notch on the center cap and prying it off the wheel.
3. Remove wheel and tire.