Prowler V6-3.5L VIN G (1999)
-
Tighten compressor bolt to 22 Nm (200 in. lbs.).
To Condenser
Fig 33 Suction And Liquid Lines
REMOVAL
1. Remove refrigerant from the A/C system using a refrigerant recovery machine.
2. Remove liquid line from condenser.
-
Remove flange bolts attaching lines to the receiver/drier.
-
Remove flange.
CAUTION: Cap all lines that are not being replaced and cap the condenser inlet.
3. Disconnect liquid line from the receiver/drier.
4. Remove the liquid line from the vehicle.
INSTALLATION
For installation, reverse the above procedures.