Prowler V6-3.5L VIN G (1999)
Oil Filter: Service and Repair
NOTE: When servicing the oil filter, avoid deforming the filter can. Install the remove/install tool band strap against the base lock seam. The lock
seam joining the can to the base is reinforced by the base plate.
1. Raise vehicle on hoist.
Oil Filter
2. Using Tool C-4065, unscrew filter from base and discard.
3. Wipe base clean, then inspect gasket contact surface.
4. Lubricate gasket of new filter with clean engine oil.
5. Install and tighten filter to 20 Nm (15 ft. lbs.) torque after gasket contacts base. Use filter wrench if necessary.
6. Lower vehicle and fill crankcase to proper oil level.
7. Start engine and check for leaks.
