Prowler V6-3.5L VIN G (1999)
9. Install power steering pressure hose in discharge fitting on power steering pump. Be sure the end of the tube and O-ring seal is squarely seated in
discharge fitting. Tighten power steering pressure hose tube nut to a torque of 29 Nm (252 inch lbs.).
10. Install side panel. Install and securely tighten the 3 bolts attaching side panel to vehicle.
CAUTION: Do not use automatic transmission fluid in power steering system. Only use Mopar (R) Power Steering Fluid or equivalent.
11. Fill power steering pump reservoir to correct fluid level.
12. Start the engine and let run for a few seconds, then turn the engine off.
13. Add fluid if necessary. Repeat the above procedure until the fluid level remains constant after running the engine.
14. Raise front wheels of vehicle off the ground.
15. Start the engine. Slowly turn the steering wheel right and left, lightly contacting the wheel stops. Then turn the engine off.
16. Add power steering fluid if necessary.
17. Lower the vehicle and turn the steering wheel slowly from lock to lock.
18. Stop the engine. Check the fluid level and refill as required.
19. If the fluid is extremely foamy, allow the vehicle to stand a few minutes and repeat the above procedure.
20. Check for leaks at all hose connections.
