Prowler V6-3.5L VIN G (1999)
5. Remove 3 bolts attaching side panel. Remove side panel by pulling upward until lower retaining clips come out of valance panel.
6. Remove power steering fluid pressure hose from discharge fitting on power steering pump.
7. Raise vehicle.
8. Remove power steering fluid pressure hose from vehicle. Pressure hose is removed from the underside of the vehicle.
9. Remove and discard the O-ring seals at the end of the power steering hose tube.
Installation
1. Using a lint free towel, wipe clean the open power steering hose ends, power steering pump discharge fitting and steering gear port.
2. Install new O-ring seals on ends of power steering hose. Lubricate NEW O-ring seals using fresh clean power steering fluid.
3. From the underside of vehicle, correctly route -power steering fluid pressure hose up to the power steering pump.
4. Correctly route power steering pressure hose to pressure fitting on steering gear. Install power steering pressure hose on steering gear. Install the
power steering pressure hose tube nut only hand tight.
NOTE: When installing routing clips they must be installed at the flat spots formed into the tubing on the power steering pressure and return hose.
