Prowler V6-3.5L VIN G (1999)
accessory drive belt noise. It also prevents the pulley from contacting the power steering pump when it is installed, causing power steering pump
or pulley damage.
2. Install the correct installation spacer into the hub of the power steering pump pulley.
3. Insert the Pulley Installer, Special Tool C-4063, (without adapters) through hole in spacer. Thread the Installer, Special Tool C-4063, or
equivalent into the end of the power steering pump shaft. Tighten the installer into shaft.
4. Holding the Pulley Installer with one wrench so it will not rotate, turn hex down threaded rod of installer pushing the pulley onto the shaft of the
power steering pump. Ensure that the tool and the pulley remain aligned with the pump shaft so pulley does not become cocked on shaft.