Prowler V6-3.5L VIN G (1999)
NOTE: The bell housing is attached to the transaxle using two different size bolts. Mark bolts when removing for assembly reference.
Fig. 3
2. Remove bell housing bolts (Fig. 3).
3. Remove inspection plug. Mark and remove converter bolts.
4. Separate bell housing from transaxle
INSTALLATION
1. Position bell housing to transaxle.
2. Install bell housing bolts. Torque larger upper bolts to 95 Nm (70 ft. lbs.). Torque smaller lower bolts to 74 Nm (45 ft. lbs.)
3. Align marks on flex plate and converter.
4. Install converter bolts. Install all bolts before tightening. Torque converter bolts to 81 Nm (60 ft. lbs.).
5. Install inspection cover.
Disassembly and Assembly
DISASSEMBLY
Fig. 4
1. Remove drain plug and drain fluid (Fig. 4).
