Voyager V6-3.3L VIN G Flex Fuel (2000)
Removing Inboard Brake Pad From Piston
8. Pull the inboard brake shoe away from the caliper piston until the retaining clip on shoe is free from the cavity in the caliper piston .
9. Repeat the above procedure on other side of the vehicle.
INSTALLATION
1. Begin on one side of the vehicle.
2. Completely retract the caliper piston back into its bore in the brake caliper (This is required for caliper installation on the brake rotor with new
brake shoes installed).
3. Remove the protective paper from the noise suppression gasket on the rear of both the inner and outer brake shoe assemblies (if applied).
Inboard Brake Shoe
4. Install the new inboard brake shoe into the caliper piston by firmly pressing its retaining clip into the piston bore. Be sure the inboard brake shoe is
