Bonneville V8-4.6L VIN Y (2004)
10. Install the MAP sensor.
11. Connect the electrical connector to the MAP sensor.
12. Install the EGR valve.
Important: The EGR valve inlet pipe incorporates a crush seal connection at the water crossover. The EGR valve inlet pipe must be replaced if
disconnected from the water crossover.
13. Hand start the NEW EGR inlet pipe-to-crossover pipe nut (1) to prevent cross-threading.
^
Tighten the EGR inlet pipe nut to 60 Nm (44 ft. lbs.).
14. Connect the EGR inlet pipe flange (3) to the water crossover.
15. Install the EGR inlet pipe-to-water crossover flange bolt (2).
^
Tighten the EGR inlet pipe bolt to 25 Nm (18 ft. lbs.).
16. Position the rear lift bracket to the water crossover.
