Fiero V6-173 2.8L (1986)
FIGURE 6 - CALIPER TO BRACKET CLEARANCE
Figure 6
^
Clearance between caliper (13) and bracket (17) stops.
^
If necessary, remove caliper and file ends of bracket (17) stops to provide proper clearance (Figure 6).
6.
Inlet fitting (15) with new washers, if removed, to 24-40 N-m (18-30 ft.lbs.).
7.
Wheels and tires, aligning previous marks.
^
Remove lug nuts securing rotor to hub.
^
Lower car.
^
Torque lug nuts. See WHEELS and TIRES.
8.
Fill master cylinder to proper lever with clean brake fluid.
FIGURE 7 - SHOE AND LINING ASSEMBLY
FIGURE 8 - REMOVING OUTBOARD SHOE
^
Bleed caliper if inlet fitting was removed.
^
Recheck fluid level.
SHOE AND LINING ASSEMBLIES
Figures 7 through 10
Remove or Disconnect
