G6 V6-3.6L (2007)
1. Use the J 41102-1A and a mallet in order to install the new case cover seal.
2. Use the J 41228 in order to install a new sleeve on the output axle. Install the J 41228 so that the collar is in the snap ring groove.
3. Install the axle shaft retaining clip onto the output axle.
4. Install the drive axle assembly.
5. Lower the vehicle.
6. Inspect the shaft sleeve for leaks.
7. Inspect the transmission oil level. Refer to Transmission Fluid Checking.
Fluid Cooler Pipe Seal Replacement
Fluid Cooler Pipe Seal Replacement
Tools Required
^
J 45201 Cooler Line Seal Remover
^
J 41239 Cooler Line Seal Remover/Installer
Removal Procedure
Caution: Ensure that the vehicle is properly supported and squarely positioned. To help avoid personal injury when a vehicle is on a
hoist, provide additional support for the vehicle on the opposite end from which the components are being removed.
1. Position the vehicle on a hoist.
2. Place a drain pan or suitable container under the vehicle.
3. Raise the vehicle.
