G6 V6-3.9L (2009)
1. Install the mode actuator.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the mode actuator retaining screws.
Tighten the screws to 1.5 Nm (13 lb in).
3. Connect the mode actuator electrical connector.
4. Install the knee bolster. Refer to Knee Bolster Replacement (See: Body and Frame/Interior Moulding / Trim/Dashboard / Instrument
Panel/Service and Repair).
5. Install the left closeout panel. Refer to Instrument Panel Insulator Panel Replacement - Left Side (See: Body and Frame/Interior Moulding /
Trim/Dashboard / Instrument Panel/Service and Repair).
6. Install the fuse labeled HVAC CTRL (BATT).
