G6 V6-3.9L (2009)
2. Use a flat-bladed tool, remove the boot clamp (2) from the constant velocity (CV) joint (1) and the boot (3).
3. Using a pair of side cutters, remove the boot clamp (4) from the boot (3) and the wheel drive shaft (5).
4. Discard the boot clamps (2) and (4). Use NEW clamps only.
5. Using a block of wood and a hammer, remove the CV joint (2) from the wheel drive shaft (1).
6. Remove the boot (1) from the wheel drive shaft (2).
7. Inspect the outer CV joint for damage and wear. Refer to Wheel Drive Shaft Outer Joint Inspection (See: Testing and Inspection/Wheel Drive
Shaft Outer Joint Inspection).
Installation Procedure