G6 V6-3.9L (2009)
Constant Velocity Joint: Service and Repair
Wheel Drive Shaft Outer Joint and Boot Replacement
Wheel Drive Shaft Outer Joint and Boot Replacement
Special Tools
*
CH-48894 Wheel Drive Shaft Boot Clamp Pliers
*
J 35910 Drive Axle Seal Clamp Pliers
Removal Procedure
1. Clamp the drive axle shaft in a soft jawed vice.
Caution: Do not cut through the wheel drive shaft inboard or outboard boot during service. Cutting through the boot may damage the sealing
surface of the housing and the tripot or the constant velocity joint bushing. Damage to the sealing surface may lead to water and dirt intrusion and
premature wear of the constant velocity joint.
