G8 V6-3.6L (2008)
10. Remove the rubber cap or plug from the BPMV (2).
11. Install the brake pipe (1) to the BPMV (2).
Tighten the brake pipe fitting to 15 Nm (11 lb ft).
12. Install the sound proofing trim to the bulkhead.
13. Install the engine. Refer to Engine Replacement (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Replacement) for 3.6L orEngine Replacement (See: Engine, Cooling and Exhaust/Engine/Service and Repair/Removal and Replacement/Engine
Replacement) for 6.0L .
14. Bleed the hydraulic brake system. Refer to Hydraulic Brake System Bleeding (Manual) (See: Brake Bleeding/Service and Repair)Hydraulic Brake
System Bleeding (Pressure) (See: Brake Bleeding/Service and Repair) .
Intermediate Brake Pipe Removal Procedure
Caution: Refer to Brake Dust Caution (See: Service Precautions/Technician Safety Information/Brake Dust Caution) .
Caution: Refer to Brake Fluid Caution (See: Service Precautions/Vehicle Damage Warnings/Brake Fluid Caution) .
Caution: Refer to Brake Fluid Irritant Caution (See: Service Precautions/Technician Safety Information/Brake Fluid Irritant Caution) .
Notice: Refer to Adding Fluid to the Brake System Notice (See: Service Precautions/Technician Safety Information/Adding Fluid to the Brake
System Notice) .
Notice: Refer to Brake Fluid Effects on Paint and Electrical Components Notice (See: Service Precautions/Vehicle Damage Warnings/Brake
Fluid Effects on Paint and Electrical Components Notice) .
1. Clean the master cylinder, brake lines and reservoir cap.
2. Place a clean suitable container under the Brake Pressure Modulator Valve (BPMV).
3. Remove the master cylinder reservoir cap.
