Grand AM V6-3.4L VIN E (2001)
4. Press the cable conduit (2) into recliner until fully seated.
2. On the front side of the recliner, if equipped with EZ Entry actuator cables perform the following steps:
1. Route the cable end (1) through the opening on the recliner.
2. Install the cable end (1) to the recliner, and install the fastener.
3. Press the fastener until fully seated against the cable end (1).
4. Push the cable conduit (5) into the opening on the recliner until locking tabs are secured.
3. Position the recliner (2) to the seat cushion frame and the seat back frame (1).
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the lower recliner bolts (3) to the seat cushion frame.
Tighten the bolts to 25 N.m (18 lb ft).
5. Install the upper recliner bolts (4) to the seat back frame (1).
Tighten the bolts to 18 N.m (13 lb ft).
6. On the inner recliner perform the following steps:
1. Route the cable end (1) through the opening in the recliner.
2. Install the cable end (1) to the recliner.
3. Rotate the cable 90 degrees.
4. Install the cable conduit (2) into the recliner opening until the locking tabs are secured.
