Grand AM V6-3.4L VIN E (2001)
3. Install the front pads to the caliper bracket.
4. Install the caliper. Refer to Brake Caliper Replacement-Front.
5. Remove the two hand tightened wheel lug nuts that retained the rotor to the hub.
6. Install the tire and wheel assembly.
7. Lower the vehicle.
8. With the engine OFF, gradually apply the brake pedal to approximately 2/3 of its travel distance.
9. Slowly release the brake pedal.
10. Wait 15 seconds, then repeat steps 8 and 9 until a firm brake pedal is obtained. This will properly seat the brake caliper pistons and brake pads.
11. Fill the master cylinder reservoir to the proper level. Refer to Master Cylinder Reservoir Filling.
12. Burnish the pads and rotors. Refer to Burnishing Pads and Rotors.
