Grand AM V6-3.4L VIN E (2001)
9. Inspect the following parts for cuts, tears, or deterioration. Replace any damaged parts:
^
The disc brake mounting and hardware. Refer to Disc Brake Mounting and Hardware Inspection-Rear.
^
The caliper dust boot. Refer to Brake Caliper Inspection.
10. Inspect the caliper bolts (1, 3) for corrosion or damage. If corrosion exists, use new components (including bushings) when installing the caliper.
Do not attempt to polish away the corrosion.
Installation Procedure
1. Bottom the piston into the caliper bore. Use an old brake pad or wooden block across the face of the piston. Use a C-clamp (3) over the caliper
housing. Tighten the clamp slowly to drive the piston into the caliper bore. Do not damage the piston or the caliper boot.
2. Install the two retainer slides to the caliper bracket.
