Grand AM V6-3.4L VIN E (2001)
Brake Adjuster: Service and Repair
Adjusting Screw Replacement
Adjusting Screw Replacement
^
Tools Required
-
J 38400 Brake Shoe Spanner and Spring Remover
Removal Procedure
Caution: Keep fingers away from rear brake shoe springs to prevent fingers from being pinched between spring and shoe web or spring and
backing plate.
1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the rear wheel and tire.
3. Remove the brake drum. Refer to Brake Drum Replacement.
Notice: Do not over stretch the adjuster spring. Damage can occur if the spring is over stretched.
4. Remove the adjuster spring (3). Disengage the adjuster spring hook end from the tab on the adjuster actuator (1).
5. Use the J 38400 in order to spread the brake shoes (1) apart.
6. Remove the adjuster.
Installation Procedure