Grand Prix V6-191 3.1L VIN M SFI (1998)
12. Install the lower connecting rod bearing into the connecting rod cap.
13. Coat the inside surfaces of the lower connecting rod bearing with new engine oil.
14. Install the connecting rod cap.
15. Install the connecting rod cap nuts.
^
Tighten the connecting rod nuts to 20 Nm (15 ft. lbs.). Use the J 36660 in order to rotate the nuts an additional 75 degrees.
NOTICE: Refer to Fastener Notice in Service Precautions.
16. Inspect the connecting rod for a binding by prying back and forth with a suitable tool. If necessary, loosen and retighten the connecting rod cap.
17. Measure the connecting rod clearance using the following procedure:
17.1. Install all connecting rod bearings.
17.2. Lightly tap each connecting rod parallel to the crankpin in order to make sure the connecting rods have clearance.
17.3. Measure the side clearance between the connecting rod caps using a feeler gage, or dial indicator. Refer to Crankpin (Rod Side Clearance)
in Engine Mechanical Specifications for the connecting rod side clearance.
18. Install the crankshaft oil deflector. Refer to Crankshaft Oil Deflector Replacement.
19. Install the oil pump. Refer to Oil Pump Replacement.
20. Install the oil pan. Refer to Oil Pan Replacement.
21. Lower the vehicle.
22. Install the cylinder head(s). Refer to Cylinder Head Replacement (Right Rear) and/or Cylinder Head Replacement (Left Front).
