Grand Prix V6-191 3.1L VIN M SFI (1998)
1. Install the case side cover inner gasket (59).
2. Install the case side cover gasket (54).
3. Install the case side cover pan (53).
4. Install the case side cover bolts (56-58).
^
Tighten the case side cover bolts (56-58) to 24 Nm (17 ft. lbs.).
NOTICE: Refer to Fastener Notice in Service Precautions.
5. Remove the drain pan from under the transaxle.
6. Adjust the jackstand to raise the left side of the frame.
7. Install the left side frame to body bolts.
8. Install the right side frame to body bolts.
9. Install the engine mount lower nuts.
10. Install the transaxle mount.
11. Install the transaxle mount bracket.
12. Remove the jackstand support from the right side of the frame.
13. Remove the jackstand support from the left side of the frame.
14. Connect the three-way catalytic converter pipe to the right (rear) exhaust manifold.
15. Install the intermediate shaft to the steering gear.
CAUTION: When installing the intermediate shaft make sure that the shaft is seated prior to pinch bolt installation. If the pinch bolt is inserted
into the coupling before shaft installation, the two mating shafts may disengage. Disengagement of the two mating shafts will cause loss of steering
control which could result in personal injury.
16. Install the pinch bolt at the intermediate steering shaft.
17. Install the left drive axle to the transaxle.
18. Connect the left lower ball joint to the steering knuckle.
19. Connect the wheel speed sensor wiring harness connector.
20. Install the left tie rod end to the steering knuckle.
21. Install the stabilizer shaft link to the lower control arms.
