Grand Prix V6-3.8L VIN 2 (2004)
21. Remove the left rear sail panel.
22. Remove the CPA from the left/driver roof rail module connector (2).
23. Disconnect the left root rail module wiring harness yellow connector (2) from the left roof rail module (3).
ENABLING PROCEDURE
1. Remove the key from the ignition switch.
2. When enabling the right/passenger seat belt pretensioner proceed to step 3, if the SDM needs enabling then use entire procedure.
3. Connect the seat belt pretensioner-right connector to the vehicle wiring harness connector (1).
4. Install the CPA to the seat belt pretensioner connector (1).
5. Connect the right roof rail module wiring harness yellow connector (2) to the right roof rail module (3).
6. Install the CPA to the right roof rail module connector (2).
7. Install the right rear sail panel.