GTO V8-6.0L VIN U (2005)
16. From inside the left foot-well, grab the edge of the hole in the front floor carpet assembly around the evaporator drain hose (1) and tear the
perforated line (2) by pulling the carpet away from the transmission tunnel.
17. Slide the remaining flap of carpet out from under the heating, ventilation and air conditioning (HVAC) unit (3) and into the right hand foot-well.
18. Remove the carpet and insulator assembly from the vehicle.
Installation Procedure
1. If a new carpet is being installed, cut the carpet along the perforated line that runs from the forward edge of the carpet, through the evaporator
drain hose (1) cutout, to the forward edge of the lower radio bracket cutout.
2. Install the carpet and insulator assembly into the vehicle.
3. Make sure that all of the cutouts in the carpet are correctly aligned.
