GTO V8-6.0L VIN U (2005)
4. Notice: Refer to Fastener Notice in Service Precautions.
Install the 2 nuts (1,2) to the booster studs.
Tighten the nuts to 10 Nm (88.5 inch lbs.).
5. If the vehicle has a manual transmission, remove the tie strap, or equivalent, and place the clutch fluid reservoir in the correct position.
6. Install the bracket (10).
7. Install the washer (6) and the bolt (7) to the bracket.
Tighten the bolt to 10 Nm (88.5 inch lbs.).
8. Install the 2 nuts (8,9) to the bracket.
Tighten the nuts to 8 Nm (70.8 inch lbs.).
9. Place a container under the master cylinder in order to catch the brake fluid.
10. Remove the caps or the plugs from the brake pipes and the master cylinder.
11. Push the 2 brake pipes (3,4) into the master cylinder ports.
12. Caution: Refer to Brake Fluid Caution - DOT 4 in Service Precautions.
Notice: When adding fluid to the brake fluid reservoir or to the clutch fluid reservoir, use only GM Vehicle Care Brake and Clutch Fluid Super
DOT-4, GM P/N 88958860 (Canadian P/N 88901244), or equivalent DOT-4 brake fluid from a clean, sealed container. This polyglycol brake
fluid is hygroscopic and absorbs moisture. Do not use fluid from an open container that may be contaminated with water. Improper or
contaminated fluid could result in damage to the system components.
Important: Ensure the brake fluid level stays above half-full.
Fill the reservoir with GM Vehicle Care Brake and Clutch Fluid, GM P/N 88958860, or the equivalent DOT-4 brake fluid.
13. Allow the fluid to drip from the ports for approximately 1 minute.
14. Tighten the 2 flare nuts.
Tighten the 2 flare nuts to 14 Nm (10 ft. lbs.).
15. Bleed the brakes.
16. Fill the reservoir.
17. Install the cap seal.
18. Install the cap.
19. Remove the container from below the master cylinder.
20. Connect the brake fluid level switch connector.
21. Install the connector security clip on the brake fluid level switch connector.
22. Install the front suspension support brace.
