GTO V8-6.0L VIN U (2005)
1. Caution: Refer to Brake Fluid Caution - DOT 4 in Service Precautions.
Lubricate the 2 sealing grommets (4,5) with GM Vehicle Care Brake and Clutch Fluid Super DOT-4, GM P/N 88958860, or the equivalent DOT-4
brake fluid.
2. Install the 2 sealing grommets to the master cylinder (8).
3. Install the reservoir (1) to the master cylinder.
4. Ensure the reservoir screw holes align with the master cylinder screw holes.
5. Install the 2 screws (6,7).
6. Notice: When adding fluid to the brake fluid reservoir or to the clutch fluid reservoir, use only GM Vehicle Care Brake and Clutch Fluid Super
DOT-4, GM P/N 88958860 (Canadian P/N 88901244), or equivalent DOT-4 brake fluid from a clean, sealed container. This polyglycol brake
fluid is hygroscopic and absorbs moisture. Do not use fluid from an open container that may be contaminated with water. Improper or
contaminated fluid could result in damage to the system components.
Fill the reservoir with GM Vehicle Care Brake and Clutch Fluid Super DOT-4, GM P/N 88958860, or the equivalent DOT-4 brake fluid.
7. Install the cap seal (3).
8. Install the cap (2).
9. Remove the container from below the master cylinder.
10. Inspect the master cylinder for fluid leakage.
11. Connect the brake fluid level switch connector.
12. Install the connector security clip on the brake fluid level switch connector.
