J2000/Sunbird V6-191 3.1L (1992)
5.
Relocate center rail weatherstrip retaining screw hole forward 4 - 5 mm (0.156 - 0.203 inch). Refer to Figure 9.
6.
Using black weatherstrip adhesive, P/N 12345097, or equivalent, install center rail weatherstrip forward in retainer.
7.
Install center rail weatherstrip retaining screw into new hole. Refer to Figure 9.
8.
Perform watertest. If waterleak is still existing, proceed to step 9.
9.
Remove center portion of center rail weatherstrip, approximately 25 mm (1.0 inch) from retainer ends. Refer to Figure 10.
10.
Apply black weatherstrip adhesive, P/N 12345097, or equivalent, in retainer.
11.
Install center rail weatherstrip into retainer while pushing weatherstrip rearward. Refer to Figure 10.
5A.
To correct center rail weatherstrip to rear rail weatherstrip puckering, use the following procedure:
1.
Lower convertible top about halfway.
2.
Lower quarter window.
3.
Remove center rail weatherstrip approximately 100 mm (4.0 inch) from the rear joint end by disconnecting clip.
4.
Install stuffers (two) into the cut-away in back of center rail weatherstrip. Refer to Figure 7. This will push the weatherstrip surface back to its
original shape.
5.
Apply black weatherstrip adhesive, P/N 12345097, or equivalent, in retainer.
6.
Install center rail weatherstrip into retainer.
