Montana AWD V6-3.4L VIN E (2004)
1. Install the coil spring (2).
2. Use the utility jack in order to raise the lower control arm and load the suspension.
3. Use the J 41820 in order to connect the ball joint to the knuckle.
4. Install the stabilizer link to the lower control arm.
5. Use the utility jack in order to support the lower control arm.
6. Install the ABS electrical connector mounting bracket.
7. Connect the ABS electrical connector.
8. Install the brake caliper mounting bracket.
9. Install the parking brake cable mounting bracket.
10. Install the brake calipers.
11. Install the wheel and tire assemblies
12. Lower the vehicle.
Coil Spring Replacement (All Wheel Drive)
Coil Spring Replacement (All Wheel Drive)
^
Tools Required
-
J 41820 Ball Joint(Stud Separator
Removal Procedure
1. Raise and support the vehicle.
2. Remove the rear wheel.
3. Remove the brake caliper and support the bake caliper. Do not disconnect the bake hose.
4. Disconnect the tie rod from the knuckle.
