Sunfire L4-144 2.4L DOHC VIN T SFI (2001)
1. Install a NEW O-ring seal to the accumulator end of the compressor hose assembly.
NOTE: Refer to Fastener Notice in Service Precautions.
2. Install the compressor hose assembly and the fitting nut to the accumulator.
Tighten
Tighten the fitting nut to 35 N.m (26 lb ft).
3. Install a NEW O-ring seal to the condenser end of the compressor hose assembly.
4. Install the compressor hose assembly to the condenser.
5. Install the fitting nut for the compressor hose assembly to the condenser.
Tighten
Tighten the compressor hose assembly to the condenser fitting nut to 16 N.m (12 lb ft).
6. Raise and support the vehicle.
7. Install NEW sealing washers on the compressor ports.
8. Install the compressor hose assembly from the compressor.
9. Install the bolt holding the compressor hose assembly to the compressor.
Tighten
Tighten the compressor hose block fitting bolt to 33 N.m (24 lb ft).
10. Install the compressor hose assembly in the hose clip on the fan shroud.
11. Lower the vehicle.
12. Connect the refrigerant pressure sensor electrical connector.
13. Install the cruise control module.
14. Install the hood close Out filler panel.
15. Evacuate and recharge the A/C system. Refer to Refrigerant Recovery and Recharging.
16. Leak test the fittings of the component using the J 39400-A.
