Torrent AWD V6-3.4L VIN F (2006)
19. Disconnect the seat belt pretensioner - RF connector.
20. Cut the seat belt pretensioner connector out of the vehicle, leaving at least 16 cm (6 in) of wire at the connector.
21. Strip 13 mm (0.5 in) of insulation from each of the connector wire leads.
22. Cut two 6.1 m (20 ft) deployment wires from a 0.8 mm (18 gage) or thicker multi-strand wire. These wires will be used for the seat belt
pretensioner deployment harness.
23. Strip 13 mm (0.5 in) of insulation from both ends of the wires cut in the previous step.
24. Twist together one end from each of the wires in order to short the wires. The deployment wires are to remain shorted, and not connected to a
power source until you are ready to deploy the seat belt pretensioner.
25. Twist together one connector wire lead to one deployment wire.
26. Inspect that the previous connection is secure.
