Vibe L4-1.8L VIN L (2003)
7. Remove 1 nut, 1 lock washer and the manual lever from the manual shaft.
8. Unstake the lock plate (1) behind the manual shaft nut (3).
9. Remove the manual shaft nut and the lock plate from the PNP switch.
10. Remove the 2 bolts and the PNP switch from the transaxle.
Installation Procedure
1. Install the PNP switch to the transaxle. Secure with 2 bolts. Do NOT tighten fully.
Notice: Refer to Fastener Notice in Service Precautions.
2. Install a new lock plate (1) and the manual shaft nut (3) onto the PNP switch.
^
Tighten the manual shaft nut to 5.5 Nm (49 inch lbs.).
3. Temporarily install the manual lever.
4. Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.
