Vibe L4-1.8L VIN L (2003)
-
The plate
-
The ring
-
The rotor
-
The rear housing
23. Install the rear housing to the front housing.
Notice:
Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings/Fastener Notice
24. Install the 4 housing bolts.
Tighten the bolts to 22 Nm (16.2 ft. lbs.).
25. Apply fluid to the sealing portion of the Power Steering Pressure (PSP) switch.
26. Install the PSP switch to the pump.
Tighten the switch to 21 Nm (15.5 ft. lbs.).
27. Apply fluid to the flow control valve hole in the front housing.
28. Apply fluid to the flow control valve spring.
29. Install the spring to the pump.
30. Apply fluid to the flow control valve.
31. Install the valve to the pump.
32. Apply fluid to a NEW pump fitting seal.
33. Install the seal to the pump fitting.
34. Install the pump fitting to the pump.
Tighten the fitting to 69 Nm (50.9 ft. lbs.).
35. Apply fluid to a NEW inlet tube seal.
36. Install the seal to the pump inlet tube.
37. Install the inlet tube to the pump.
38. Install the pump inlet tube bolt.
Tighten the bolt to 12 Nm (106.2 inch lbs.).
39. Install the pump to the vehicle.
