Vibe L4-1.8L VIN L (2003)
1. Install the rear transaxle mount into the rear transaxle mounting bracket.
2. Secure the rear transaxle mount with the through bolt. Do NOT fully tighten the through bolt.
3. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the 3 nuts and 1 bolt to secure the rear transaxle mount to the transmission support.
^
Tighten the nuts and bolt to 52 Nm (38 ft. lbs.).
5. Lower the vehicle.
6. Tighten the through bolt.
^
Tighten the through bolt to 87 Nm (64 ft. lbs.).
7. Remove the engine support fixture from the engine.
