Vibe L4-1.8L VIN L (2003)
1. Position the clutch pedal assembly in the vehicle.
2. Connect the CPP switch electrical connector.
3. Connect the CCR switch electrical connector.
Notice: Refer to Fastener Notice in Service Precautions.
4. Install the 2 clutch pedal retaining nuts and 1 bolt.
^
Tighten the retaining nuts to 12 Nm (106 inch lbs.).
^
Tighten the retaining bolt to 19 Nm (14 ft. lbs.).
5. Install the clevis clip and the pin.
6. Install the Lower Instrument Panel.
7. Connect the negative battery cable.
