Vibe FWD L4-2.4L (2009)
2. Install the remote control door lock receiver (1) to the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
3. Install the bolt (3) to the door lock receiver (1).
Tighten the remote control door lock receiver bolt to 10 Nm (89 lb in).
4. Connect the remote control door lock receiver electrical connector (2).
5. Install the right upper quarter panel trim. Refer to Quarter Upper Trim Panel Replacement (See: Body and Frame/Interior Moulding / Trim/Trim
Panel/Service and Repair).
6. Connect the negative battery cable.
7. Reprogram the remote control door lock receiver, if necessary. Refer to Control Module References (See: Testing and Inspection/Programming
and Relearning).
