Vibe FWD L4-2.4L (2009)
5. Disconnect vehicle communication interface module electrical connectors (1).
6. Remove the three nuts (2).
7. Remove the vehicle communication interface module from the vehicle.
Installation Procedure
1. Position the vehicle communication interface module (3) in the vehicle.
Caution: Refer to Fastener Caution (See: Service Precautions/Vehicle Damage Warnings/Fastener Caution).
2. Install the three nuts (2).
Tighten the nuts (2) to 7.5 Nm (66 lb in).
3. Connect vehicle communication interface module electrical connectors (1).